Download Gemalto Card Readers drivers, firmware, bios, tools, utilities. Download the 'Sentinel Driver' from here. At the time of writing, the Sentinel driver for Windows is at version 7.6.0 described as 'Sentinel System Driver Installer for Sentinel SuperPro, UltraPro and SHK' Before starting, ensure that your USB Sentinel is unplugged. Unzip the archive and run the Sentinel System Driver Installer. SafeNet Synchronization Agent Prior to March 1, 2021, users must upgrade Sync Agents v3.5 or earlier to the latest release. Failure to upgrade will result in the failure of all user sync transactions after that date. Note: The latest Sync Agent is available to download from the Support Portal.

Please elaborate on the following from the Concept Board Hardware Interface Description:

Gemalto Drivers

> EHS6 enumerates, i.e., registers with the USB host, as a CDC-ACM
> Composite USB device supporting eight separate interfaces. This
> is the Composite Communication enumeration.
> Under Microsoft® Windows XPTM, Microsoft® Windows Vista® and
> Microsoft® Windows 7 this USB device implements a Modem port (a
> virtual USB Modem port) plus six further communication ports as well as a
> reserved port. The Modem port as well as the ports enumerated 3 to 5 are
> AT command interfaces, i.e., these ports are accessible by AT command
> and may be used as control and data interfaces.

Linux registers 7 ttyACM interfaces (0 to 6).
ttyACM0 responds to AT commands
ttyACM1 and 2 do not
ttyACM3 responds to AT commands but with echo feature deactivated (can be activated with ATE1 command
ttyACM4 and 5 respond to AT with echo enabled
ttyACM6 does not speak AT

Please explain the difference between the communication channels. The remarks about the Windows drivers seems to apply, port 0 and 3-5 speak AT. Please also explain the exact purpose of each port (including 1, 2 and 6) so I can perhaps get this right in the Linux cdc-acm driver with the correct dialects.

> The interfaces - with the exception of the reserved port - are controlled by
> separate device drivers running on the Windows host. These drivers may
> be standard USB drivers integrated in Windows. The driver configuration
> files for Windows (.inf files) are supplied by Gemalto and need to be
> installed before the device can be used.

Gemalto Smart Card Driver Windows 10

Where can I find the Windows drivers? They weren't included in the package and I cannot find a download link. These might provide me with some hints.